ORGONE BOOSTER DISC 101
The Orgone Booster Disc was developed with Adam at Berkana Labs and is an official 3rd party booster disc for Berkana Labs products.
The ‘orgone’ energy produced by the disc provides more operative ‘fuel’ for manifestation workings. Clients report 2-4x faster manifestation with the booster disc.
INSTRUCTIONS:
Our booster discs are made to pair with Berkana Labs equipment but can be used with any Radionics Board. We recommend using a board with an input and output plate and dials. In this example we are using the Berkana Labs ‘Spooky2 Radionics’ 3-Dial board.
Here we are using an example of a financial manifestation, with a written statement on the input circle.
The written manifestion should always be written in the present tense, for example:
THE HOUSE IS SOLD, not THE HOUSE WILL SELL
If you say the THE HOUSE WILL SELL, what the universe hears is the house isn’t sold yet! You write the phase a fact, it has already happened.
The final step is to draw a circle around the statement.
Next place the booster disc on top of the written manifestation on the input circle. On the output circle place a ‘witness’. The witness is the target of the manifestation.
In the case of selling a house we can use a photo of the property as a witness, a paper printout of a photo, or the street address of the property - or a combination of the above.
Next place a quartz crystal on the output circle, on top of the witness to boost the radionic working. Quartz is a natural amplifier and will boost any signal or energy.
The final step is to tune the dials. There are several options to use the Berkana Labs Stick Plate to dowse the correct rate, use a pendulum to zero in on the correct rate for each dial, or intution as you turn each dial.
Close-up of a quartz crystal tower. The larger the quartz the more the signal is boosted on the output.
I usually run a manifestation for a day, turn it off and observe any changes that happen. If nothing happens in 4-7 days repeat the manifestion.
The instructions for the XL Booster Disc are similar to the regular booster disc, the only difference is an extension plate is attached to the input of the 3-Dial board.
We have the written manifestation on the extension plate and a witness on the output circle of the 3-Dial board. the equipment should be chained as following:
SPOOKY2 GENERATOR OUTPUT - TO EXTENSION PLATE INPUT, EXTENSION PLATE OUTPUT - TO 3-DIAL BOARD INPUT
The final step is to place the XL Booster Disc on the extension plate, place a quartz crystal on the witness (the output circle), and tune the dials.
In Conclusion:
The workflow is relatively simple, you are already on your Radionics Journey! If you have any interesting feedback let us know!
