RADIONIC BOARD 101
INSTRUCTIONS FOR THE RADIONIC BOARD
The board has a scalar antenna that harmonizes the energy in your space, and doubles as a radionic machine, primarily for manifestation. The board is powered by a 5V AC and transmits a single 7.83Hz frequency, the ‘Schumann Earth Resonance’ which has a calming effect. It is also a classic frequency for transmitting Radionic workings.
BASIC SET UP
First plug in the AC cable, and the LED light should turn on. There are 3 modes:
Flashing Light mode (strongest signal)
Constant Light mode (medium signal)
Low Light mode (weakest signal)
I use the constant light mode as I find the flashing mode annoying, but use what you feel is best. The constant light mode is more than enough for radionic workings and plenty strong for EMF protection.
The last step is to put a quartz crystal on the board as a signal booster. If you’re only using the board as an energy tool for EMF protection thats all you have to do! If the light is too bright when going to sleep you can use the low light mode or put a light cloth over it to block the light.
RADIONIC MANIFESTATIONS
Proper Radionic boards have and input and output surface and typically rotary dials to ‘tune’ the working or enter radionics rates. This board only has one surface and no dials, so it’s primed for Radionic Manifestions - quickening the time for an event to happen. Pure minimalism - its just you and the board.
THE WRITTEN MANIFESTATION
The written manifestion should always be written in the present tense, for example selling a property:
THE HOUSE IS SOLD, not THE HOUSE WILL SELL
If you say the THE HOUSE WILL SELL, what the universe hears is the house isn’t sold yet! You write the phase as its a fact, it has already happened.
The final step is to draw a circle around the statement.
Next place the written intention on the board. You can also place a photo of the property on top of the written intention and / or write the house address on a paper and place it on top of the written intention as a target (called a witness in radionics). I personally just use the written intention.
The final step is placing a quartz crystal on top of the paper written intention to boost the working (quartz is an amplifier). I let the working run for a day turn it off and wait a few days to a week and if nothing happens I repeat the steps outline above.
PRACTICES TO IMPROVE THE WORKING:
MEDITATION - The more balanced you are the more powerful the outcome
DOWSING - Dowsing YES / NO with a pendulum strengthens your internal compass. Self knowledge and confidence is key.
BE RELAXED - Trying to control the outcome of a working blocks the manifestion. If you desire a certain outcome too much it’s less likely to happen. Set it and forget it!
I always do radionics workings in the highest good. With radionics workings the Laws of Karma apply.
-Masaki
